PortalForum Q&A Section DOT Information and Questions Tire Pressure monitoring systems

Summer Seminar Information

Tire Pressure monitoring systems

Discuss NYS DOT Regulations


Posts: 94
Location: dryden, ny
1
Memorandum
To: Supervising Motor Vehicle Inspectors
CC: Bus Operators
From: Rusty Seastrum Chief Technician
Date: 3/26/2013
Re: Tire Pressure Monitoring Systems
Effective April 15, 2013, vehicles that are equipped or required to be equipped with a tire pressure monitor system are to be inspected for functionality of the system.
A system that is determined to be defective or non-functional as designed is to be identified with defect code 52.04 Other Unsafe Operational Problems and assigned an “A” on the MC300 form and indicated to have a tire pressure monitoring system defect.
Vehicles built after September 1, 2008, which were factory equipped, shall not have the pressure monitoring system disabled. As inspections occur, the operator of a vehicle that may have disabled the system prior to April 15, 2013, is to be given 30 days to have the system properly enabled, until October 15, 2013. A system that has been disabled during the said time frame shall be identified as a 99.02 defect and CFR49 571.138 cited on the MC300 inspection form.
If tire pressure can be adjusted and a warning light extinguished then the system is not to be addressed on the MC300 inspection form.

Return to DOT Information and Questions



cron